signal produced

3525 PWM signal produced, through driving circuit, drives IGBT module work, the main circuit adopts the structure of the whole bridge;

3525产生的PWM信号，通过驱动电路，驱动IGBT模块工作，升压高频变压器采用铁基非晶材料磁芯，输出采用高压直流叠加方法；

The measurement of relative gain of preamplifier with PD signal produced by light source

用光源信号测试BES3量能器用前放的相对增益

Three-phase alternating frequency modulation control signal produced by 8051 CPU is magnified to control the switch of the silicon controlled rectifier in inverse main bridge circuit, thereby constant pressure speed-adjusting is realized.

由8051CPU产生三相交流调频控制信号，经放大来控制逆变主桥路中可控硅晶闸管的通断，从而实现恒压调速。

The signal of a nitrogen-centered radical adduct of DMPO was observed. The results obtained indicate that the trapped radical is a cation radical of diamine produced from diamine and photogenerated hole.

观察到DMPO与氮中心自由基加合物的ESR信号，表明捕捉到的自由基是脂二胺与光生空穴作用而产生的胺的阳离子自由基。

Presently, EOG is the only eye movement recording method whose signal is produced by bio electricity.

眼电图EOG( electro-oculography)方法是目前唯一一种信号产生于生物电的眼运动记录技术.

This paper may be the first to apply a CMAC network inverse filter system in robot PVDF tactile sen-sor field. The system effectively eliminated the structure error which is produced in the process of converting tactile sensor stress signal to object outline.

本文首次在机器人PVDF触觉传感器领域使用了基于CMAC神经网络的逆滤波系统，目的是消除在通过触觉传感器的应力信息反求被触摸物体的轮廓过程中系统模型产生的结构误差。

The differential signal is the spike pulse signal that is produced by differential circuit. Original differential circuit is very difficult to obtain the ideal differential signal.

微分信号是由微分电路产生的一种尖峰脉冲信号，原来的微分电路很难获得理想的微分信号。

Electrical signal produced by Nd-glass laser radiation breakdown of a ceramic thin plate

钕玻璃脉冲激光击穿陶瓷片时产生的电信号

A loud warning signal produced by a burglar alarm.

夜盗警钟发出的响亮的警报信号。

The transducer adopts integrated intelligence power module IPM. SPWM control signal is produced by special chip, in inverter VVVF at one time is completed.

它采用集成化的智能功率模块IPM，正弦形脉冲宽度调制控制信号由专用芯片产生，在逆变器内同时完成变频变压。

The excitation method which residual signal produced from baseband extraction and high frequency, reproduction is introduced.

对基带提取&高频再生残余信号的激励方式亦作了相应的介绍。

It is found that selecting appropriate value of duty cycles of Gauss light pulse signal, frequency chirp and the roll-off factor of raised cosine pulse signal produced by the equalizer of an optical receiver can improve the sensitivity of the optical receiver.

发现适当选取高斯光脉冲信号的占空比、啁啾分量、光接收机均衡滤波器输出的升余弦频谱波形滚降因子的值可以提高光接收机灵敏度；